Carl Gustaf Mauser Scout Mount - Includes Rings - S&K Scope Mounts

Carl Gustaf Mauser Scout Mount - Includes Rings - S&K Scope Mounts

Item #: SKCG65


Out of Stock
Place on back-order to ship when back in stock. We will only charge you when it ships out the door.

We do not double-charge shipping on back-orders. You only pay shipping once.

Manufacturer MPN:
S&K Mounts CG65

UPC: none
Weight: 2.00 pounds

Product Description

For the Carl Gustaf Swedish Mauser. This mount will also replace the rear sight on 6.5mm Swedish Mausers.

No drilling, tapping or major alteration. Guaranteed to hold zero. Can be removed and reinstalled easily. Includes 1" fully machined, horizontally split scope rings and is windage adjustable. Requires a long eye relief scope. Made in the USA of top grade military allan aircraft aluminum.

\Will not fit 1914 Carl Gustafson 6.5 x 55.
Will not fit Model 94

Installation instructions for the CARL GUSTOF

Remove the rear sight ladder by pushing the hinge pin out with a 1/16” punch. Remove the leaf spring by sliding it forward (a strike with a punch & hammer might be required to dislodge it). Slide the special nut (with the short part of the head toward the rear) into the spring slot & all the way toward the rear of the slot. 

Set the S&K mount over the rear sight so the screw holes in the front of the S&K mount line up with the horizontal hinge pin holes in the rifle. Align the rear hole in the top of the S&K mount up with the special nut. It is very important that these holes all line up to keep from damaging the threads when the screws are installed. 

Put the two 4-40 x 5/16th socket head screws through the hinge pin holes in the receiver & into the tapped side holes in the mount. Do not tighten at this time. 

Put the 10-32 x ¾” flat head screw through the hole in the top of the mount & into the special nut but do not tighten. Now tighten the 4-40 socket head screws - You don’t need to get the (2) 4-40 screws very tight! Now tighten the 10-32 flat head screw. 

Screw the 10-32 x ½” socket set screw into the top of the mount in the front hole, screw the 10-32 x 3/8” socket set screw in the rear hole and tighten both.  This will hold upward pressure on the mount, eliminating any movement in the mount & locking the 4-40 screws in place. Do not try to tighten or loosen the 4-40 screws with the 10-32 set screw tight as you will damage or break the 4-40 screws.

Related Categories That You May Also Be Interested In:
 Mauser Accessories |  Mauser Scope Mounts |  S&K Scope Mounts |  S&K Scope Mounts |