Scope Mount for Carl Gustaf 94 Mauser Scout. Does not include rings. Uses weaver style rings.

No drilling, tapping or major alteration. Guaranteed to hold zero. Can be removed and reinstalled easily. Requires a long eye relief scope. Made in the USA of top grade military allan aircraft aluminum. Rings not included - accepts Weaver rings.

Installation instructions for the CG94 Carl Gustaf 94 (1916) Weaver Scout

To install this mount, it is necessary to remove the rear sight from your 94. To remove the sight push out the pivot pin & remove the ladder sight & spring under the ladder sight.

After removal of the rear sight please insert the special tapped nut supplied with your S&K mount into the slot that the spring came out of. Place the nut in the slot with radius on the base toward the rear. Place the bottom part of the S&K mount into the 3/8 wide slot at the rear of the receiver where the pin was removed keeping the front hole on the underside of the mount over top of the special tapered nut installed into the spring slot.

 Align the side holes in the mount up with the holes in the receiver. This alignment is critical to keep from cross threading the screw in the tapped holes of the mount. Put the two 4-40 x 3/8 socket head cap screws into the side holes that the pin was removed from but do not tighten. Put the 10-32 x 3/8 flathead screw down through the top of the mount & into the special tapped nut & tighten. Snug the (2) 4-40 screws. Do not make them real tight.

 Insert the10-32 x ½ socket set screw through the top of the mount & tighten (this screw keeps the 4-40 screws tight). Normally it isn't necessary to use thread lock on the mounting screws but if you do decide to use thread lock DO NOT use thread lock on the 4-40 screws.