Ruger 10/22 Fixed Dragunov Fiberforce Gun Stock - Fixed Stock - ATI
The classic Dragunov look to enhance your 10/22.

This Fiberforce Stock for Ruger 10/22 is designed to fit standard barrel 10/22. Will not work with bull barrels or the Ruger 10/22 Takedown.
Features a thumbhole grip stock for a stronger grip and can be used with either open sights or with a scope.
Includes dowel sling mount, ventilated forearm, and handguard, built-in cheekrest, sling swivel studs.

Material: DuPont Polymer
Color: Black
Fits: Most Ruger 10/22. Fits pre- and post-ban Ruger 10/22.
Distance from front of pistol grip to end of buttstock is 13 inches.

Will NOT fit Ruger 10/22 Takedown, 22 Magnum or Bull Barrels.
Made in the USA

Features:
Thumbhole Grip Stock
Dragunov/Military Design
Lightweight
Ventilated Forearm and Handguard
Built-in Cheekrest
Sling Swivel Studs
Dowel Sling Mount
Scratch Resistant
Weatherproof
Easy Drop- in Installation
DuPont Extreme Temperature Glass Reinforced Polymer Stock

Limited Lifetime Warranty

Ruger 10/22 Fiberforce Stock

1: Sling Stud Installation

Begin by turning the stock upside down and locating the hole for the sling stud at the front of the stock. Next using an adjustable wrench tighten one sling stud until seated.
Locate the other hole for the sling stud at the rear of the stock. Using an adjustable wrench tighten one sling stud until seated.

2: Barreled Action Installation

Install the rear of the barreled action/trigger housing into the Fiberforce stock until seated.
Note: If a problem develops in getting the receiver properly seated, check the safety button to be sure it is not catching on the stock. You may also want to ensure the trigger group pin is flush.
Next, bring the barrel down until seated into the stock.

3: Take Down Screw Installation

Turn the stock over and locate the take down screw hole and using the original take down screw and appropriate driver, tighten until seated.

4: Handguard Installation

Take the handguard and align the front tabs of the stock with the front slots of the handguard. Continue to match the tabs and slots until the top handguard is seated onto the stock body.