When installed on the base of a 5.56x45 rifle magazine, the Magpul provides unsurpassed speed and controllability during high stress, tactical magazine changes.  Features durable thermoplastic loop with recessed rough gripping surface.  Quick and easy installation and removal.  Patended design based upon the tried-and-true para-cord loops and duct-tape tabs currently in use with special warfare units worldwide. Made in U.S.A.

Pack of 3

The Magpul fits most aluminum, steel, and polymer 5.56 x 45 magazines.

Platform: AR15, M4, M16

                Install/Removal Instructions

Step 1:  Place one end of the Magpul over the base (bottom) of the magazine.

Step 2: Using index finger, stretch the base of the Magpul over the base of the magazine.

Step 3: Using both index fingers, work each side down a little until the top lip of the Magpul is approximately 1/8” below the base of the magazine.

To remove the Magpul, grip the finger loop firmly with the index finger while using the other hand to lightly grip the magazine. Pull with steady pressure and the Magpul will pull off.

Storage:

The Magpul is made of an industrial thermoplastic which is impervious to most chemicals and will retain its shape even after long term storage in a closed ammunition pouch.

Depending on the operating temperature and the amount of time stored, there may be some memory effect (keeping shape after prolonged, compressed storage) on the finger loop, but not enough to affect its usability.