Schmidt Rubin 1911 Scout Mount - Includes Rings - S&K Scope Mounts


Schmidt+Rubin+1911+Scout+Mount+-+Includes+Rings+-+S%26K+Scope+Mounts

Processing...
Item #: SK9665

$81.95

In Stock for Immediate Shipping
Qty

Manufacturer MPN:
S&K Mounts 9665

UPC: none
Weight: 2.00 pounds


Product Description

No drilling, tapping or major alteration. Guaranteed to hold zero. Can be removed and reinstalled easily. Includes 1" fully machined, horizontally split scope rings and is windage adjustable. Requires a long eye relief scope. Made in the USA of top grade military allan aircraft aluminum. Does not fit carbine rifle.

Installation instructions for the Swiss Rubin 1911


Push the pin out at the front of the rear sight. Remove the spring by lifting up at the rear and sliding it reward. Slide the flange nut into the under cut at the front of the sight where the spring was. Place the mount over the flange nut with the (2) 4-40 tapped holes toward the barrel end. 

Line the 4-40 tapped holes in the mount with the holes in the side of the receiver. It is very important that these holes line up to keep from damaging the threads when the screws are installed. Put in the (2) 4-40 socket head screws. DO NOT TIGHTEN!! 

Place a pin drill etc. through the countersunk hole in the top of the mount and into the hole in the special nut. Move the nut around with the pin until the round part of the nut slips into the counter bore in the bottom of the mount. Put the 10 – 32 x ¾ flat head screw through the mount and into the nut. Tighten this screw and the (2) 4-40 screws. You don’t need to get the (2) 4-40 screws very tight! Put the 10-32 x ½ set screws down through the tapped hole in the top of the mount and tighten against receiver.

Related Categories That You May Also Be Interested In:
 Rifle Mounts and Bases |  S&K Scope Mounts |  S&K Scope Mounts |
•••••