MOE AR15 M16 Replacement Pistol Grip - Black - Magpul

Product Description
MOE Grip
Installation Instructions:
Step 1: Remove original Grip
Turn rifle
upside down. Remove grip per armory guidelines, taking care not to lose the
fire control selector/safety detent parts held in place by the grip. Remove
selector spring, leaving the selector detent in place.
Step: 2 Remove Grip Cap
To remove
the Grip Cap, use thumb and middle finger to hold the Cap Extensions that stick
out either side. Using index finger, push the Cap Locking Tab towards the rear
of the grip at the same time pulling the cap down and free of the grip body.
Step 3: Position Grip
Verify
selector detent is in the receiver and install selector spring in the Grip body
right side top hole. Fit MOE Grip onto lower receiver, making sure the selector
spring engages the receiver hole without binding.
Step 4: Install MOE Grip
Using
a flat-head screwdriver, install the supplied Pan-Head Screw through the front
hole and hand tighten to receiver.
A locking compound
is factory applied to prevent loosening. DO NOT re-use original mounting
screw/lock washer.
Step 5: Verify Install
IMPORTANT:
Test safety selector and general function prior to firing.
Perform final
inspection including function check per US Army TM 9-1005-319-23&P Unite
and Direct Support Maintenance Manual (3-97) to verify proper weapon
functions.
Always
test fire your weapon before using it in an operational environment.
Related Categories That You May Also Be Interested In:
AR15 M4 M16 Grips | Magpul Industries | Replacement Grips |