Steyr M95 Infantry Scout Mount Weaver Long Ladder - S&K Scope Mounts


Steyr+M95+Infantry+Scout+Mount+Weaver+Long+Ladder+-+S%26K+Scope+Mounts

Processing...
Item #: SK9070

$72.95

In Stock for Immediate Shipping
Qty

Manufacturer MPN:
S&K Mounts 9070

UPC: none
Weight: 2.00 pounds


Product Description

No drilling, tapping or major alteration. Guaranteed to hold zero. Can be removed and reinstalled easily. Made in the USA of top grade military allan aircraft aluminum. Use Weaver type rings (not included). Requires a long eye relief scope.

Installation instructions for the STYER M95 INFANTRY
(Long Ladder Rear Sight)

Push the pin out at the rear of the flip up sight. Remove the top wood over the barrel. Remove the spring by lifting up at the rear and sliding it forward. Slide the flange nut into the under cut at the front of the sight where the spring was & re-install the top wood cover. 

Place the mount over the flange nut with the (2) 4-40 tapped holes toward the butt end. Line the 4-40 tapped holes in the mount up with the holes in the side of the receiver and put in the (2) 4-40 socket head screws.  It is very important that these holes line up to keep from damaging the threads when the screws are installed. DO NOT TIGHTEN! 

Move the nut around with a pin through the hole in the mount until the round part of the nut slips into the counterbore in the bottom of the mount. Put the 10-32 x ½”  flat head screw through the mount and into the nut. Tighten this screw and then the (2) 4-40 socket head screws. The 4-40 screws don’t need to be real tight! 

Put the 10-32 x ½ set screw down through the tapped hole in the top of the mount and tighten against the receiver. The purpose of the set screws is to keep pressure on the 4-40 socket head screws. Do not try to remove the 4-40 screws with the set screw tight!

You can also get some vertical adjustment with the set screw if you find your gun is shooting low & you don’t have enough adjustment with your scope. This can be done by loosening the 10-32 flat head screw & turning the set screw clockwise. For every ¼ turn of the 10-32 set screw you will move approximately 8” at 100 yards. Be careful if you do this as a small turn of this screw moves the vertical position quite a bit. Retighten the 10-32 flathead screw.


Related Categories That You May Also Be Interested In:
 S&K Scope Mounts |  S&K Scope Mounts |